Cable Management

I accept no responsibility for blown up PSUs and motherboards if you follow these tips.
Time do do something about the PSU cables. I decided to braid them in white. On reflection, I wish I'd had chose black. Oh well.

I guess the warranty's void now!

I needed to remove the pins from the 24, 4, and 8 pin motherboard connectors, you can buy a specialist tool to do this, which costs about £5.00.... or you can use a staple, bent appropriately.

Push the staple down into the plug so that the ends of the staple are either side of the connector. The staple is in the top left connector.

This will compress the barbs holding the connector in, you can then just pull the connector out of the back of the plug, you can see the barbs on either side of the connector.

Remember to number the cables as you take them out.

Slide the cable braid over the cable. I also wrap double sided tape around the braid so that the braid won't pull out of the heatshrink (you can just see it in this pic).

Slide over the heatshrink

And use a heat-gun, or your girlfriends hairdryer to shrink it on.

Remember to renumber the cables as you work. All that's left is to reassemble the plug, remember to prise the barbs open a little before you insert the connector.

Trial Fitting

I thought I'd try the motherboard & PSU to see if they needed any adjustment before finally screwing them down.
Motherboard



PSU
Rear Panel Insert

Everything fitted exactly as it should, the motherboard mounting holes and the power supply fittings supplied with the case lined up perfectly. I wonder if a cheaper case would be as good.

(Yes, I know the PSU is upside down!)